![]() With enabled, Custom/Chamfered Rectangular pads placed on Paste or Solder Mask layers were not displayed. With the option enabled (in Advanced Settings), duplicating a design rule would lead to a sizable number of false violations being detected by the DRC. It was not possible to save a custom-defined material to the Altium Material Library as while a new row could be added and defined, the Save and OK buttons were disabled. When running a DRC for a Matched Lengths or Length rule from the PCB Rules And Violations panel, violations were not being presented if xSignals were used in a rule. Vias with mixed-layer structure (blind, buried) were incorrectly rendered for a panelized PCB, but correct for the source PCB.įor a design including backdrills starting from the middle of the board (using a multi-lamination process), incorrect pad sizes were being generated in Gerber and ODB++ data. ( BC:21381)įor a specific panelized PCB, a placed drill table was not showing blind and buried vias. ( BC:21443).Ī false clearance violation would occur between regular and custom shape pads when the center axis of the regular pad coincided with the edge coordinate of the custom pad shape. There was a considerable performance slowdown when adding larger numbers of stitching vias (>100,000) to a board.Ĭhanging X/Y values for a pad on an overlay layer (or the Drill Guide/Drill Drawing layer) would change the pad in the design space, but show as 0, 0 in the Properties panel. In some cases, Altium Designer would randomly and periodically freeze when performing various, different actions within the PCB Editor. In generated ODB++ and Gerber X2 output for a specific design, the drill layers with microvias were incorrect for a panelized board with mixed layers. In some cases when working with a schematic document, an Access Violation (at address 000000014B336E58 in module "AdvSch.dll") would be encountered. In some cases when working with a schematic document, the error "EIntfCastError: Interface not supported" would be encountered. In some cases, extra junctions would appear when moving some objects on a schematic sheet. For a summary of new features and subsequent improvements in Altium Designer 23, see New in Altium Designer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |